11
Installation and Operation
STARTING
The machine only starts with a voluntary action on the control device: white button “1” for the starting control.
STOP
For the stop control push the black button “0”. In case of momentary or extended stop, all food products must
be removed to get the machine to function again.
FUNCTIONING SAFETY
If the machine is under stress or is exposed to long functioning times or overload, the thermal protection
function will stop the machine. In this case, wait until it is completely cooled before proceeding to the starting
function.
VOLTAGE LACKING
In the case of the electric feeding breaking of if the machine is disconnected, the machine will only be restarted
after the electric feeding is back or there is re-connection to the power source.
PRESSURE OPENING - ONLY FOR UNITS WITH MICRO SWITCH
Lifting the handle of the grater mouth stops the machine immediately because of the safety micro switch
function. The machine can be restarted by lowering the handle and closing the mouth of the machine and
pressing the on switch again.
CONTROLS AND VERIFICATIONS BEFORE STARTING
VERIFICATION / CONTROL
MODALITY AND CHECKS
Check that:
• Extraneous objects aren’t on the machine, inside the
grater mouth and in dispensing zone of the grated
product.
Visually check the indicated parts, check if
objects or extraneous objects around the
machine. Make sure there is not food product left
over. In case of its presence, remove them.
Check the cleaning:
• Of the grater mouth, of the pressure and grater roll.
• The external surface of the machine.
Visually check all parts and surfaces to verify
their cleaning. Disassemble to check internal
parts. In case of mold or other types of dirtiness,
follow the cleaning procedures indicated in
chapter 5.
Check the integrity:
• Of the fixed protections.
• Of the machine body, grater mouth, pressure and the
grater roll.
All fixed protections must perform their function.
Verify the integrity of the external surface. The
parts must be replaced at first sight of erosion or
breaking.
Check the functionality:
• Of control system parts / control about the safety.
• Of the control devices.
All devices must perform desired function. The
actuators and all parts must be changed at first
sight of erosion or breaking.
Summary of Contents for GR-IT-0373
