Omcan F300TCV, Instruction Manual, Page: 19 / 44

19
Troubleshooting
The table below indicates the most common problems that may arise during slicing and the necessary
remedies.
PROBLEM POSSIBLE CAUSE REMEDY
The machine does not start
when the start-up button (white
or green button) is pressed or
switch is turned.
• No power supply • Ascertain that the plug is
correctly inserted
• Defective electrical control
circuit
• Check
• Call technical assistance
The machine starts, but the
functioning light is not on.
• Defective indicator • Do not use the machine
when the pilot lamp is
not on; promptly ask for
technical assistance
The machine starts, but there
are vibrations. The motor is very
hot and there is a bad smell.
• Defective motor or
transmission.
• Do no use the machine;
promptly ask for technical
assistance
Under strain, the machine slows
down or comes to a stop.
• Defective transmission • Ask for technical assistance
Excessive resistance to product
slicing.
• The blade is blunt • Sharpen the blade
The slices are ragged and/or
shaped irregularly
• The blade is blunt • Sharpen the blade
• The blade is excessively
worn out
• Ask for technical assistance
Unsatisfactory blade sharpening • Worn wheels • Replace the wheels;
• Ask for technical assistance
The product tray doesn’t slide • Guides are insufficiently
lubricated
• Lubricate
When the stop button is
pressed or turned, the machine
does not stop
• Defective electrical control
circuit
• Stop the machine, unplug
from mains and ask for
technical assistance
Unusual noise of transmission • Loose belt • Adjust belt tension
DISMANTLING THE SLICER
These machines are made of the following elements:
• Aluminium frame;
• Stainless steel fittings and others;
• Electrical parts and cords;
• Electrical motor;
• Plastic materials, etc.
Whether dismantling is entrusted to third parties please note that disposal of the materials can only be carried