8
Operation
Maintenance
The bone saw must be frequently cleaned, any product residue will putrefy and will cause pollution and
infection of products that will be subsequently work.
LUBRICATION
After each washing, grease the rollers with some drops of oil type SHELL ONDINA 15 or ESSO MARCOL 82
or similar oil marking sure that they rotate while they are being lubricated.
BANDSAW MACHINE OPERATION (UNLOCKED SEMI-FEED CARRIAGE)
WARNING:
Check that the machine is disconnected.
1.
Pull and rotate the clamping device so that the sliding plate can slide.
2.
Adjust the slice thickness plate to the thickness of cut required and lock it with the handle
(Figure 17)
.
3. The depth of cut can be adjusted. Rotate horizontally the clamping handle, position the blade guide and
lock it by rotating the handle to the stroke end
(Figure 18)
.
4. Lift the pusher
(Figure 19)
.
5.
Place carefully the goods on the feed carriage towards the protection bridge and the pusher
(Figure 20).
6. Turn on the bandsaw machine by rotating the switch in a clockwise direction
(Figure 21)
.
7. With a light pressure on the goods towards the slice thickness control, push the sliding plate towards the
blade
(Figure 22)
.
8. To stop the machine turn the switch in a counterclockwise direction to 0-OFF
(Figure 23)
.
BANDSAW MACHINE OPERATION (LOCKED SEMI-FEED CARRIAGE)
WARNING:
Check that the machine is disconnected.
1.
Pull and rotate the clamping device to lock the sliding semi-plate
(Figure 24).
2. Remove the pusher from the protection bridge
(Figure 25)
.
3. Rotate the bridge under the sliding semi-plate. In this position, the sliding semi-plate is locked
(Figure 26)
.
4.
Adjust the thickness plate to the thickness of cut required and lock it by the handle
(Figure 27)
.
5. The depth of cut can be adjusted. Rotate horizontally the clamping handle and position the blade guide and
lock by turning the handle to the stroke end
(Figure 28)
.
6. Turn on the bandsaw machine by rotating the switch in a clockwise direction.
WARNING: Lift the pusher with your right hand away from the blade. Put the product to be cut on the slide
thickness plate and with the pusher in your left hand push the product holder towards the blade until the cut
is complete
(Figure 29)
.
7. To stop the machine, turn the switch in a counterclockwise direction to 0-OFF.
IMPORTANT:
In case of power failure during the functioning, the machine will stop. When the power returns,
turn the switch to 0-OFF and then to 1-ON to restart the machine.
