Omcan BE-IT-0015A, Instruction Manual

Page: 7 / 40

7
Installation
TRANSPORT
The machine must be transported in its original packaging. It must be moved with an adequate lifting system to
avoid damaging it and injuring yourself.
• Do not position anything on the package.
• The machine must always be transported in a vertical position.
UNPACKING
The machine can be sent packaged with a pallet and cardboard, cage or crate. The packaged machine can
therefore by lifted with a forklift or pallet truck by inserting the forks in the specific spaces prepared under the
packaging. It can also be lifted with a crane, passing the ropes or straps under the packaging. In this case,
comply with the maximum tensioning angle of the ropes which must be 45°.
Remove the packaging vertically. Carefully unpack the machine and check there are no signs of damage from
transport. If found, promptly inform the carrier. You are always advised to photograph the damage. Remove the
fastening brackets as in the figure and, using a forklift (or a lifting device), remove the machine from the pallet.
To ensure further staff safety, you are advised to maintain a sufficient distance from the machine when it is
being lifted.
POSITIONING AND MAINTENANCE
The machine must only be installed by qualified and authorised staff. The machine must only be used for the
purpose of dividing or dividing and rounding dough. The warranty is not valid if changes are made without the
manufacturer’s authorisation and/or if non-original spare parts are used. Use of nonoriginal spare parts can
damage the machine and/or harm the operator. The machine must be positioned on a solid and regular floor.
The machine is very stable.
ELECTRICAL CONNECTION
A qualified technician should carry out installation and an electrician should connect the machine to the power
supply system. Firstly check the voltage and the connection phases are equal to those of the machine (see
identification plate). If this is not the case, contact the retailer. Check the rotation direction of the motor on the
machine. Turn the main knob to position I-ON. Close the guard casing and run an “empty” work cycle. Check if
the shaping plate oscillates. If this is not the case, an electrician must invert the phases, i.e. he must invert the
two cables in the power plug to change the rotation direction of the motor.
DISPOSAL OF THE MACHINE
When you want to dispose of an entire machine, parts or just the packaging, you must comply with the
waste disposal rules. Specifications regarding the material on the various parts can be obtained from the
manufacturer.