www.microscopenet.com
- 4 -
2
Installation
2.1 Installation of the binocular viewing head
1) Loosen the head lock thumb screw (
Fig. 1
) on the
top of the microscope body.
Note:
The thumb screw may not be pre-installed. Please
find it in the same package of the microscope.
2) Remove the cap on the circular dovetail of the
binocular viewing head.
3) Insert the binocular viewing head into the top of the microscope body; ensure that
the dovetail is completely seated into the socket and tighten the thumb screw.
Caution
:
Do not release the viewing head from your hand grip until you are sure the viewing
head is installed securely.
2.2 Installation of the eyepieces
1) Remove the protective caps from the eyepiece tubes.
2) Insert the eyepieces into the eyepiece tubes.
2.3 Installation of the glass filter
1) Swing out the color filter holder under the condenser.
2) Place the filter into the holder as shown in
Fig. 2
, swing the holder in.
2.4 Installation of the camera
(optional, may not included in your package)
1) Take off the eyepiece from the eyepiece tube.
2) Insert the camera into the eyepiece tube, and then
connect the camera to a computer via USB2.0
cable. See
Fig. 3
.
3) The manual for the camera is on a CD (or mini CD).
Refer to the manual to install the driver and
software on to the computer.
4) The camera is optional and may have different
Fig. 2
Fig. 1
Head Lock Thumb Screw
Fig. 3
Camera
Color Filter
Color Filter Holder
