Page
5
from
38
1.2.2.
Protection Circuits
There are 11 special protection circuits used in the amplifier. They are activated when one or
more of next parameters exceed defined values or some unwanted occasion occurs.
•
VSWR too high
•
Input power too high
•
Output power too high
•
Plate voltage too low
•
Anode current too high
•
Screen current too high
•
Grid current too high
•
Mistuning of PA
•
Hot switching protection
•
Soft start for protecting your fuses
•
“switch-on blocking “ at opened amplifier
1.2.3.
Indicators
There are couples of LED and bar graph indicators visible on the front panel to inform you
about value of some parameters or operation status:
Bar graph indicators
Power output
- 50 LEDs
Reflected power
- 20 LEDs
Ig2 current
- 10 LEDs
Anode voltage, anode current, tuning - 30 LEDs
LED Indicators
Current at control grid (Ig1) - 2 LEDs
WAIT
- preheating of tube (150 sec.)
STBY
- standby
OPR
- operation mode
FAULT
- failure, switching off for abt. 2 sec.
INHIBIT
- operating condition
ANT 1
- which ANT is in use
ANT 2
- which ANT is in use
ANT
- ANT selection
Buttons
UP – DWN
- listing in menu
MAN
- manual operating
AUTO
- automatic operating
TUNE
- tuning
SET
– confirms selected parameter
OSD Indicator
LCD Display 2 x 16 characters
Summary of Contents for X8NOM4000A
