TRX support settings
Press SET button and scroll using UP / DWN to CHOOSE TCVR
Confirm CHOOSE TCVR by pressing SET again and scroll UP / DWN to desired TRX Type.
Confirm the selection by pressing SET
Continue by selecting Baud Rate
Below – Baud rate for TRX – PA communication displayed by OSD
By scrolling UP / DWN select desired Baud Rate which must be same as baud rate used by
connected TRX.( please refer to your TRX user guide)To confirm your selection press SET.
When using Yaesu TRX you need to configure STOP BITs parameter and confirm selection
with SET.
Communication settings menu can be left by pressing AUTO by pressing the AUTO button
PA will enter AUTO mode but only if all settings are correct and connection has been
established. You can check if correct frequency and TRX type has been displayed on OSD
Summary of Contents for OM2500 A
