Olympus XZ-10, Instruction Manual

Page: 13 / 89

13 EN
Basic photography
2
Switching the information display
Press the
INFO
button to choose the information displayed when shooting.
INFO INFO
INFO INFO INFO INFO
Histogram display Information display on
L N
01:02:03 01:02:03
38 38
F5.6 P 0.0 0.0
ISO
200
125 125
HD
L N
01:02:03 01:02:03
38 38
F5.6 P 0.0 0.0
ISO
200
125 125
HD
Image only
Histogram display
Displays a histogram showing the distribution of brightness in the image. The horizontal axis
gives the brightness, the vertical axis the number of pixels of each brightness in the image.
Areas above the upper limit at shooting are displayed in red, those below the lower limit in
blue, and the area metered using spot metering in green.
Using the shooting modes
“Point-and-shoot” photography (
P
program mode)
In mode
P
, the camera automatically adjusts
shutter speed and aperture in response to
subject brightness. Set the mode dial to
P
.
• The shutter speed and aperture selected by
the camera are displayed in the monitor.
• The shutter speed and aperture displays
flash if the camera is unable to achieve
optimal exposure.
125 125 F5.6
01:02:03 01:02:03
38 38
L N
P 0.0 0.0
ISO
400
HD
Shooting mode
Shutter speed Aperture value
Warning display
example (blinking)
Status Action
30" 30" F1.8 F1.8
The subject is too dark. Use the flash.
2000 2000 F8 F8
The subject is too bright.
The metered range of the camera is
exceeded. Set [ND Filter Setting] to
[On].
g
“Using live control” (P. 31)
Program shift (
%
)
In
P
mode, you can use the control ring to change the
combination of aperture value and shutter speed while
maintaining the correct exposure. “
s ” appears next to the
shooting mode during program shift. To cancel program
shift, rotate the control ring backwards until “
s ” is no longer
displayed.
• Program shift is not available when you are using a flash.
250 125 F5.6
01:02:03 01:02:03
38 38
L N
P
s
0.0 0.0
ISO
400
HD
Program shift