![background image](http://html2.mh-extra.com/html/olympus/tg-3/tg-3_instruction-manual_4307524108.webp)
108
EN
Monitor
Monitor
•
Do not push the monitor forcibly; otherwise the image may become vague, resulting in a playback mode failure
or damage to the monitor.
•
A strip of light may appear on the top/bottom of the monitor, but this is not a malfunction.
•
When a subject is viewed diagonally in the camera, the edges may appear zigzagged on the monitor. This is not
a malfunction; it will be less noticeable in playback mode.
•
In places subject to low temperatures, the monitor may take a long time to turn on or its color may change
temporarily. When using the camera in extremely cold places, it is a good idea to occasionally place it in a warm
place. The monitor exhibiting poor performance due to low temperatures will recover in normal temperatures.
•
The monitor of this product is manufactured with high-quality accuracy, however, there may be a stuck or
dead pixel on the monitor. These pixels do not have any in
fl
uence on the image to be saved. Because of the
characteristics, the unevenness of the color or brightness may also be found depending on the angle, but this is
due to the structure of the monitor. This is not a malfunction.
Legal and Other Notices
Legal and Other Notices
•
Olympus makes no representations or warranties regarding any damages, or bene
fi
t expected by using this unit
lawfully, or any request from a third person, which are caused by the inappropriate use of this product.
•
Olympus makes no representations or warranties regarding any damages or any bene
fi
t expected by using this
unit lawfully which are caused by erasing picture data.
Disclaimer of Warranty
Disclaimer of Warranty
•
Olympus makes no representations or warranties, either expressed or implied, by or concerning any content of
these written materials or software, and in no event shall be liable for any implied warranty of merchantability
or
fi
tness for any particular purpose or for any consequential, incidental or indirect damages (including but not
limited to damages for loss of business pro
fi
ts, business interruption and loss of business information) arising
from the use or inability to use these written materials or software or equipment. Some countries do not allow the
exclusion or limitation of liability for consequential or incidental damages or of the implied warranty, so the above
limitations may not apply to you.
•
Olympus reserves all rights to this manual.
Warning
Warning
Unauthorized photographing or use of copyrighted material may violate applicable copyright laws. Olympus
assumes no responsibility for unauthorized photographing, use or other acts that infringe upon the rights of
copyright owners.
Copyright Notice
Copyright Notice
All rights reserved. No part of these written materials or this software may be reproduced or used in any form
or by any means, electronic or mechanical, including photocopying and recording or the use of any type of
information storage and retrieval system, without the prior written permission of Olympus. No liability is assumed
with respect to the use of the information contained in these written materials or software, or for damages
resulting from the use of the information contained therein. Olympus reserves the right to alter the features and
contents of this publication or software without obligation or advance notice.
FCC Notice
FCC Notice
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part
15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference
in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or more of the following measures:
•
Reorient or relocate the receiving antenna.
•
Increase the separation between the equipment and receiver.
•
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.