Olympus PT-EP05L, Instruction Manual

Page: 30 / 184

EN 3
En
• Locations with high temperature and humidity or with extreme temperature changes
• Locations with volatile substances
3 Opening and closing at locations with much sand, dust, or dirt may impair the waterproof
characteristic and cause water leakage. This should be avoided.
4 This product is not a case to soften impacts to the camera inside the product. When this product with
a digital camera inside is subjected to impacts or heavy objects are placed onto it, the digital camera
may be damaged. Please handle it with sufficient care.
5 Do not use the following chemicals for cleaning, corrosion prevention, prevention of fogging, repair
or other purposes. When these are used for the Case directly or indirectly (with the chemicals in
vaporized state), they may cause cracking under high pressure or other problems.
6 Jumping into the water with the Case in your hand, throwing the Case from a boat or ship into the
water, and other rough handling may cause water leakage. Please handle with sufficient care, when
handing it over from hand to hand etc.
7 There is the light circuitry inside, so do not let the inside of the Case getting wet.
8 If the Case interior or the camera should become wet because of water leakage, etc., immediately
wipe off all moisture and contact your local service station or dealer.
9 Be careful not to apply excessive force to the zoom dial, accessory mount or tripod seat.
0 Remove the O-ring when traveling by air. Otherwise air pressure may make it impossible to open the
Case.
a For safe use of the digital camera in this product, please read the “Instruction Manual” for the digital
camera carefully.
b When sealing this product, take sufficient care that no foreign matter gets caught at the O-ring and
the contact surface. It is caused for water leakage.
c The lens port cannot be removed.
d Do not use as an underwater torch for diving.
Chemicals which cannot be
used
Explanation
Volatile organic solvents,
chemical detergents
Do not clean the Case with alcohol, gasoline, thinner or other volatile
organic solvents or with chemical detergents etc. Pure water or
lukewarm water is sufficient for cleaning.
Anticorrosion agent
Do not use anticorrosion agents. Pure water is sufficient when washing
the metal parts as stainless steel and brass are used.
Commercial defogging
agents Do not use commercial defogging agents. Always use the specified
desiccant silica gel.
Grease other than specified
silicone grease Use only the specified silicone grease for the O-ring, as otherwise the
O-ring surface may deteriorate and water leakage may occur.
Adhesive
Do not use adhesive for repairs or other purposes. When repair is
required, please contact a dealer or a service station of OLYMPUS
IMAGING CORP.
PT-EP05L_06L_EN01.fm Page 3 Thursday, July 21, 2011 11:18 AM