Olympus PT-E02, Instruction Manual

Page: 61 / 284

E-20
En
Insert the digital camera in the Case.
Load the digital camera in the Case after checking the following:
• Is the digital camera turned OFF?
• Is a medium loaded in the digital camera?
• Is the battery fully charged?
• Have the strap, lens cap and filter been removed from the digital camera?
• Is the camera table provided with the Case attached to the tripod screw hole on the
bottom of the digital camera?
• Has the viewfinder eyecup of the finder of the digital camera been removed?
• Is the zoom gear attached to the camera lens?
• Is the camera’s LCD monitor stored on the camera side?
• Is the camera’ eyepiece shutter open?
(1) Pull out the zoom dial and mode dial on the Case (pulling out the mode dial also pulls up
the power switch lever) so that they do not get in the way while loading the digital camera.
Set the power switch lever and eyepiece shutter lever as shown below.
(2) Remove the TTL cable connector cap from the hot shoe connector on the top left
corner of the inner side of the front lid of the Case. Connect the hot shoe cable to the
connector.
Set to the 6:00 o’clock position.
(Power switch lever) (Eyepiece shutter lever)
Set to the 4:00 o’clock position.
Remove the cap by turning
it counterclockwise.
: • When screwing in the hot shoe connector clamping screw, place the Case
upside down. Be careful not to drop the Case.
CAUTION