82
Chapter 10 Troubleshooting
High definition LCD monitor OEV261H
Malfunction
Cause
Remedy
The monitor does not
power up.
The power cord is not connected.
Connect the power cord as described in
the instructions page 24.
The DC cord is not connected.
Connect the DC cord as described in the
instructions on page 24.
The AC adapter has not been powered up. Power up the AC adapter.
The mobile workstation has not been
powered up.
Power up the mobile workstation.
No image
The video system center has not been
powered up.
Power up the video system center.
The button for switching input signals has
been incorrectly set.
Use the INPUT button on the front panel to
select an appropriate terminal.
The monitor cable has not been
connected.
Connect the monitor cable.
The monitor cable is damaged.
Replace the broken monitor cable with a
new cable and connect it.
Monitor settings cannot be
changed.
CONTROL LOCK is set to ON.
Cancel the lock according to the
instructions on page 73.
The monitor cannot be
remote controlled.
The monitor remote cable has not been
connected.
Connect the remote cable.
The monitor remote cable is damaged.
Replace the broken monitor remote cable
with a new cable and connect it.
“NO SIGNAL” appears at
the top left of the screen.
The video system center has not been
powered up.
Power up the video system center.
The button for switching input signals has
been incorrectly set.
Use the INPUT button on the front panel to
select an appropriate terminal.
The monitor cable has not been
connected.
Connect the monitor cable.
The monitor cable is damaged.
Replace the broken monitor cable with a
new cable and connect it.
“UNSUPPORT SIGNAL”
appears at the top left of
the screen.
The button for switching input signals has
been incorrectly set.
Use the INPUT button on the front panel to
select an appropriate terminal.
No SDI image
The button for switching input signals has
been incorrectly set.
Use the INPUT button on the front panel to
select “SDI1” or “SDI2”.
The cable has not been connected.
Connect a cable to the SDI input terminal.
No image and the tally
flashes orange.
This symptom may be caused by a
malfunctioning LCD panel backlight or
inverter circuit.
Turn the power monitor off, wait
10 seconds or more and turn the power on
again. If the abnormality cannot be solved,
contact Olympus.