4
NORTEC 600 — Getting Started Guide
To Install or Replace the Lithium-Ion Battery
1.
Unfold the instrument stand.
2.
Unscrew the two thumb screws securing the
battery compartment cover at the back of the
instrument.
3.
Remove the battery compartment cover.
4.
Remove the battery and/or install the new
battery (P/N: 600-BAT-L-2 [U8760058]) in the
battery compartment.
5.
Check the cover gasket to make sure it is
clean and in good condition.
6.
Install the battery compartment cover, and
then tighten the two thumb screws.
To Install the MicroSD Card
1.
Remove the MicroSD card (P/N: MICROSD-
ADP-2GB [U8779307]) from its packaging.
2.
Loosen the two thumb screws, and then
open the instrument I/O door.
3.
Hold the card so that the MicroSD card label
faces toward the rear of the instrument.
4.
Gently slide the card into the MicroSD slot
until it clicks.
To remove the MicroSD card from the instrument, gently push the card into the slot and release. A
spring-loaded mechanism will partially eject the card, and then you can grasp and remove it from the
instrument.
Lithium-ion battery
Instrument stand
Battery
compartment cover
MicroSD
card
Thumb
screws (two)
MicroSD card slot
NOTE
