Software reference (CDU) i--SPEED LT
42
i
--SPEED LT,
i
--SPEED 2
`
Trigger Position Control
This control sets the length of the trigger delay, so that the trigger
point will appear at a user--settable position in the recorded video
clip. With the trigger position at 0%, the trigger delay is equal to the
length of the circular buffer and the trigger point will appear at the
beginning of the video clip. With the trigger position at 100%, the
trigger counter is set to zero and the recording will stop immediately
the trigger is activated, thus the trigger point will appear at the end
of the video clip. There are a number of options available in
between 0% and 100%.
NOTE
This control is not available in ROC and BROC modes.
`
Burst Time Control
This sets the length of the bursts recorded when the trigger is
activated in BROC mode.
NOTE
This control is not available in normal trigger or ROC
modes.
`
Clear Last Control
Pressing this control deletes the last burst recorded in ROC or
BROC mode.
NOTE
This control is not available in normal trigger mode, or if
no burst is available for deletion.
`
Clear Mem Control
Pressing this control deletes the entire contents of the memory,
permitting further use of the ROC or BROC modes.
NOTE
This control is not available in normal trigger mode, or if
no burst is available for deletion.
Summary of Contents for i-SPEED 2
Page 1: ...INSTRUCTIONS High Speed Video Camera System i SPEED LT i SPEED 2...
Page 2: ......
Page 115: ......
