![background image](http://html1.mh-extra.com/html/olympus/e-pl5/e-pl5_instruction-manual_4251091110.webp)
110 EN
Information
10
3
Adjust the settings for each group in the super control panel.
Flash intensity
value
250
250 F5.6 0.0
0.0
P
38
38
A Mode
TTL
M
Off
+5.0
TTL
+3.0
1/8
–
LO
1
Ch
Group
• Select the fl ash control
mode and adjust the fl ash
intensity separately for
each group. For MANUAL,
select the fl ash intensity.
Normal fl ash/Super FP fl ash
• Switch between normal
fl ash and Super FP fl ash.
Communication light level
• Set the communication
light level to [HI], [MID],
or [LO].
Channel
• Set the communication
channel to the same
channel used on the fl ash.
Flash
intensity
Flash control
mode
Adjust settings for the
camera fl ash unit.
4
Attach the supplied fl ash unit and raise the fl ash head.
• After confi rming that the built-in and remote fl ash units have charged, take a test shot.
Wireless fl ash control range
Position the wireless fl ash units with their remote sensors facing the camera. The following
illustration shows the approximate ranges at which the fl ash units can be positioned. The
actual control range varies with local conditions.
7m
5m
100°
100°
50°
50°
50°
50°
60°
60°
30°
30°
30°
30°
#
Cautions
• We recommend using a single group of up to three remote fl ash units.
• Remote fl ash units cannot be used for second curtain slow synchronization or anti-shock
exposures longer than 4 seconds.
• If the subject is too close to the camera, the control fl ashes emitted by the supplied fl ash
may affect exposure (this effect can be reduced by reducing the output of the supplied
fl ash by, for example, using a diffuser).
• The upper limit of fl ash synchronization timing is 1/160 sec. when using the fl ash in
remote control mode.
Other external fl ash units
Note the following when using a third-party fl ash unit mounted on the camera hot shoe:
• Using obsolete fl ash units that apply currents of more than about 24 V to the camera hot
shoe X-contact will damage the camera.
• Connecting fl ash units with signal contacts that do not conform to Olympus specifi cations
may damage the camera.
• Use only with the camera in shooting mode
M
at shutter speeds slower than 1/160 s and
at ISO settings other than [Auto].
• Flash control can only be performed by manually setting the fl ash to the ISO sensitivity
and aperture values selected with the camera. Flash brightness can be adjusted by
adjusting either ISO sensitivity or aperture.
• Use a fl ash with an angle of illumination suited to the lens. Angle of illumination is usually
expressed using 35-mm format equivalent focal lengths.