![background image](http://html1.mh-extra.com/html/olympus/e-m5mark-ii/e-m5mark-ii_instruction-manual_4249020142.webp)
142
EN
Using separately sold accessories
9
3
Adjust the settings for each group in the LV super control panel.
250
250 F5.6
P
38
38
A Mode
TTL
M
Off
+5.0
TTL
+3.0
1/8
–
LO
1
Ch
Flash intensity value
Group
• Select the
fl
ash control
mode and adjust the
fl
ash
intensity separately for
each group. For MANUAL,
select the
fl
ash intensity.
Normal
fl
ash/Super FP
fl
ash
• Switch between normal
fl
ash and Super FP
fl
ash.
Communication light level
• Set the communication
light level to [HI], [MID],
or [LO].
Channel
• Set the communication
channel to the same
channel used on the
fl
ash.
Flash intensity
Flash control
mode
Adjust settings for the camera
fl
ash unit.
4
Attach the supplied
fl
ash unit and turn on the camera.
• After con
fi
rming that the built-in and remote
fl
ash units have charged, take a test shot.
Wireless
fl
ash control range
Position the wireless
fl
ash units with their
remote sensors facing the camera. The
following illustration shows the approximate
ranges at which the
fl
ash units can be
positioned. The actual control range varies
with local conditions.
7m
5m
100°
100°
50°
50°
50°
50°
60°
60°
30°
30°
30°
30°
Cautions
• We recommend using a single group of up to three remote
fl
ash units.
• Remote
fl
ash units cannot be used for second curtain slow synchronization or anti-shock
exposures longer than 4 seconds.
• If the subject is too close to the camera, the control
fl
ashes emitted by the camera
fl
ash
may affect exposure (this effect can be reduced by reducing the output of the camera
fl
ash by, for example, using a diffuser).
• The upper limit of
fl
ash synchronization timing is 1/160 sec. when using the
fl
ash in RC
mode.