1
1
2
2
3
3
4
4
A
A
B
B
REV
SHEET
OF
PN 10450 Olympus BX40
Illuminator Installation Instructions
4
4
3
Han-Seung Yang
10/30/2017
NOTE - This photo shows the older R1 cable, which was came out of the illuminator assembly and plugged into the pot
plate. The new R2 cable comes attached to the pot plate and plugs into the bottom of the illuminator.
(No microscope was available for photos of the installation with the new cable)
Replace the back cover of the microscope.
Install PN 10736 rubber plug into the AC power recepticle to deter
application of obsolete and potentially dangerous voltage to the
microscope.
Plug in the power supply and the installation is complete.
Photo with old cable - new cable shown on sheet 3.
Replacement Illuminator Installation Instructions - Olympus BX40
Copyright 2017 Nanodyne Measurement Systems. Document authorized for installation of Nanodyne equipment only.
1
2
3
