DMTA-10009-01EN [U8778346], Rev. D, November 2016
Chapter 3
46
7.
If you want to cancel the editing operation and return to the original parameter
value, on the virtual keyboard, highlight
CANCEL
, and then press
[ENTER]
.
8.
To complete the editing of the parameter value, on the virtual keyboard, highlight
DONE
, and then press
[ENTER]
.
When editing a multiple line parameter value, highlighting
DONE
and pressing
[ENTER]
moves the cursor to the next line. You can also press
[2nd F], [
]
to accept
the text and move the cursor to the next line.
3.4.2
Editing Text Parameters Using the Traditional Method
When the text edit mode is set to
TRADITIONAL
, you select each character from a
hidden circular list of standard sorted letters, numbers, and special characters (see
Figure 3-8 on page 46). Only upper case letters are available.
Figure 3
‑
8 The character cycle of the traditional text edit method
NOTE
[
]
Cycling begins at “A” when the
original character is a letter
Cycling begins at “0” when the
original character is a digit
[
]
Summary of Contents for 38DL PLUS
