Panic Alarm
G
24
Panic Alarm
You can activate a panic alarm as a deterrent by pressing the
button on the base
unit or the
button on the remote control unit, depending on the configuration. The
panic alarm is triggered immediately without any delay.
To switch off the panic alarm, enter your 4-digit Entry Code on the base unit. Confirm it by
pressing
. Or, you can press the
button on the remote control.
Emergency Call (SOS)
You can trigger the SOS (emergency call) function by pressing the
button on the
base unit or the
button on the remote control unit, depending on the configuration. The
internal telephone dialling unit is automatically activated when phone numbers have been
stored. The emergency call number is dialled first, then up to 10 stored phone numbers in
succession . A voice message requests the subscriber called to press the
[1]
button on
their phone/mobile. The handsfree function is automatically activated and enables commu
nication between the caller and subscriber called.
There are three ways to end the SOS function:
a) Enter your 4-digit Entry Code on the base unit and confirm it by pressing
the
button.
b) Press the
button on the remote control.
c) The subscriber called takes the call, executes a function within 24 seconds
(refer to "Activating the Internal Telephone Dialling Unit with OGM" function)
and ends the call.
Remote Access Via Telephone
The wireless alarm system can be operated by remote access using a telephone. You can
use a telephone to activate or deactivate the alarm system and switch the handsfree and
screening functions on.
NOTE: The base unit takes your call after 8 rings. Answering
machines operate according to the same principles of
taking a call after a specific number of rings. For this
reason, you must not connect an answering machine to
the same telephone connection to which the alarm sys
tem is connected.
Proceed as follows to operate your alarm system by remote access using a telephone:
1. Dial the phone number of the telephone connection to which your alarm system is
connected.
2. Wait until the alarm system takes the call following the eighth ring. You will hear a
long acoustic signal.
NOTE: As soon as a connection is established with the alarm
system, "
Remote…
"
appears in the base unit's display.
3. Enter your 4-digit Entry Code.
4. When you enter the Entry Code correctly, you hear 2 short acoustic signals. If you
enter the Entry Code incorrectly 3 times, the connection is interrupted.
5. Use the keypad on your telephone to execute the following functions (refer to table).
The monitoring functions are confirmed by a voice message.
