Page
2
from
2
INSTALLATION INSTRUCTIONS
1. Install the included mounting accessories to hook the
device from the mounting holes (fig. 1)
.
2.
Unfasten the 4 mounting screws to remove the front plastic
cover (fig. 1)
.
3. Make sure that the battery’s cables are connected to the
respective poles. Black cable to (-) pole and red cable to (+)
pole.
4. Install the included
cable gland or the
rubber o-ring. Pass
thru the mains cable
and stabilize it by
fastening the cable
gland.
Connect the wires to
the terminal blocks
L
for live wire and
Ν
for
neutral
.
5.
Refit with care the
front plastic cover, by
fastening the 4
mounting screws
(tightening torque 1Nm).
m i n i m u m a u t o n o n o u s d u r a t i o n b y
disconnecting the mains power supply
.
Count
the time that the
lamps light and in case of less time than the
minimum autonomous duration the batteries
must be replaced. If the measured time is
c o n s i d e r a b l y l e s s t h a n t h e m i n i m u m
autonomous duration
contact the installer.
The replacement of the battery and the light
source must be done using parts of the same
type, by the manufacturer or by a competent
person.
5.
In case of inactive use for a period greater
than 2 months, disconnect the battery by
pulling out the battery’s connector.
6.
I
s not allowed to discard batteries in to
t i
common trash bins, they must be
discarded only
in battery recycling
points. Do not incinerate.
NOTE:
LED= Light Emitting Diode
LABELING EXPLANATION:
X: Self contained
0: Non-maintained
(*)
A: Including test device
*
6
0: 1 hour duration
*90: 1,5 hour duration
18
0:
3
hour duration
(*)
Non-Maintained operation: The luminaire
lights its illumination source,
only in power
supply’s failure.
Maintained operation: The luminaire lights its
illumination source, when it is powered by the
mains power supply or not
.
Battery replacement.
It can be done only by a competent person and
after the mains interruption.
1 .
F o l l o w t h e s t e p 2
o
f t h e i n s t a l l a t i o n
procedure.
2.
Disconnect the
cables
and remove the old
battery.
3.
Connect the new battery with the same type
(step
3
of the installation procedure) and place it
in the position
of the old one.
4.
Follow the step 5 of the installation procedure
and power the device..
3
4
L
N
1
Minimum distance from lighted objects.
NOTE!!
After finishing the installation you must power the luminaire at least for 24 hours for battery
charging to perform the named autonomy.
923029
0
00_
23
_0
23
TEST
button
Cover
retaining
screws
Fig
.
1
Mounting holes
Charge
indicator
Power
indicator