Olympia A 245 Combo, Operating Instructions Manual

Page: 38 / 150

38
8 Troubleshooting
Problem Diagnosis & Cause Solution
The power plug is not
plugged into the power
socket properly.
Connect the power plug in
the power socket properly.
The On/Off witch is set to
OFF .
Set the On/Off switch to ON .
POWER indicator
does not light up
The POWER indicator is
defective.
Contact our Hotline.
Laminated foil is
not completely
transparent
The laminating temperature
was too low.
Ensure that you allow the
device sufficient time to heat
up when using thicker
lamination foil (100 or 125
mic).
Laminate the same foil again
to improve the lamination
result.
The lamination foil was
inserted askew in the
laminator infeed.
Foil jam
The lamination foil is too
large.
Refer to Chapter "Clearing
jammed lamination foil".
Refer to Chapter “Cleaning
the transport rollers”.
Insert the lamination foil in
the laminator infeed straight
and with the closed side first.
Only use lamination foil of the
specified sizes, refer to
Chapter "Technical Data".
The device no
longer works after
a longer period in
operation or stops
during operation Is the surface of the device
hot? If so, the device's
overheating protection has
probably switched the
laminator off automatically.
Wait for approx. 30 minutes
and try to laminate again. If
the device does not work,
contact our Hotline.
The transport
rollers do not run
Is the power plug connected
to the power socket?
Is the On/Off switch is set to
ON ?
If the problem continues,
contact our Hotline.
If the problem cannot be solved, contact our Hotline; refer to Chapter
“Guarantee”.