35
6.2.2
Cutting material
1. Place the device on a stable, level surface with the cutting head facing
up.
2. Slide the cutting head to one side of the guide rail
3. Slide the material to be cut under the transparent pressing rail at the
required position.
Note:
Observe the permissible quantity of material which may be cut,
refer to Chapter Intended Use or Technical Data.
Note:
The visual positioning aids simplify correct alignment of the
material to be cut.
4. Hold the material to be cut firmly with one hand so that it cannot slip
when cut. Otherwise, the cut may be inaccurate.
5. To complete the cut, press the cutting head down and slide it along the
guide rail to the other side, refer to Fig. 2.
Note:
To prevent a faulty cutting edge, do not run the cutting head
back again but remove the cut material directly after completing the
cut.
Fig. 2
Summary of Contents for A 245 Combo
