Olympia A 245 Combo, Manual

Page: 18 / 86

18
g
Warning ! Risk of injury through the feed mechanism. Loose items could get caught in
the insertion slot and cause injuries. Keep fingers, hair, scarves, ties, jewellery etc. well
away from the infeed.
Warning ! Risk of tripping due to improperly laid power cable. Lay the power cable in
such a way that nobody can trip over it. Make sure the power plug and cable cannot be
damaged. Never twist the power cable. Do not operate the device if the power cable or
power plug is damaged. If the power cable is damaged, it must be replaced by a skilled
electrician to avoid any risks.
Warning ! Risk to health through harmful vapours. Vapours which are damaging to
health can develop during lamination. Always ensure good ventilation during lamination,
by opening a window for example.
Warning ! You must not attempt to laminate any metallic or plastic items (iron, copper,
aluminium etc.).
Warning ! Never remove the cover and do not dismantle the device.
Caution ! Risk of burns through hot machine surface! During the laminating process,
the machine surface heats up. Do not touch the machine surface during the laminating
operation. Wait a few minutes after laminating until the laminator has cooled down
before you touch it.
Caution ! Risk of burns through hot laminating pouch. When the laminating pouch is
ejected after lamination, it is extremely hot. Only remove the lamination pouch by
holding it at the cooled end.
Caution
! Risk of burns through hot residual laminated material. After cleaning, very hot
residual laminated material is stuck to the ejected paper. Only remove the paper
discharged by holding it at the cooled end.
Attention! Risk of property damage. Avoid exposing the device to environmental
influences such as smoke, dust, vibration, chemicals, moisture, heat or direct sunlight.
Only use the laminator in indoor areas and within the ambient conditions permitted and
stipulated in "Technical Data". Do not use the device in the vicinity of hot surfaces or in
damp environments.
Attention!
The device is only intended for cutting paper, card, photo paper and
lamination foil. Before cutting, remove any staples or paper clips from the document.
Attention! Ensure that the On/Off switch is in the OFF position before connecting the
laminator to the mains power supply.