Olympia A 245 Combo, Manual

Page: 22 / 86

22
g
Hot Lamination
1
Set the On/Off switch
7
to HOT (II) .
Ä
The transport rollers start to rotate.
Ä
The POWER LED
5
lights up RED .
2
Wait 2 - 3 minutes until the laminator has warmed up.
Ä
The READY LED
6
turns GREEN , when the device has reached the required operat-
ing temperature. The POWER LED
5
lights up
RED
.
Ä
The laminator has been put into operation.
Cold and Hot Lamination
1
Prepare the laminating pouch for insertion into the device. Insert the paper centred and
along the presealed edge of the laminating pouch. Do not use any laminating pouches which
are thicker than 125 micron per side.
2
When the device has reached the operating temperature, place the laminating pouch in the
insertion slot on the front of the device until it is clamped in the transport rollers.
Attention! Never insert the laminating pouch between the device leading with the
open edge.
The laminating pouch is transported through the device and is discharged at the output
12
.
Caution ! Risk of burns through hot laminating pouch. When the laminating pouch
is ejected after lamination, it is extremely hot. Only remove the lamination pouch by
holding it at the cooled end.
Ä
The laminating process is completed.
Switching the Laminator Off
Switch the laminator off when the laminator no longer needs to be used. This prevents others
injuring themselves on the laminator inadvertently.
1
Set the On/Off switch
7
to
OFF (O)
.
2
Disconnect the power plug from the power socket.
Ä
Operation of the laminator has been ended.
Using the Cutting Device and Corner Rounder
When required, you can cut the paper to be laminated or the laminating pouch to size using the
cutting device and cut the corners of the pouch with the corner rounder
2
. The cutting device is
on the top side of the laminator.
Attention!
Please note that you must not insert more than three sheets of paper
(80 g/m²) and not more than one laminated document in the cutting device or
corner rounder
2
at a time.