Page
3
from
3
923029009_09_012
WARRANTY
Olympia Electronics guarantees the quality, condition and operation of the goods. The period of warranty is specified in the official catalogue of
Olympia Electronics and also in the technical leaflet, which accompanies each product. This warranty ceases to exist if the buyer does not follow
the technical instructions included in official documents given by Olympia Electronics or if the buyer modifies the goods provided or has any repairs
or re-setting done by a third party, unless Olympia Electronics has fully agreed to them in writing.
Products that have been damaged can be
returned to the premises of our company for repair or replacement, as long as the warranty period is valid.
Olympia Electronics reserves the right to repair or to replace the returned goods and to or not charge the buyer depending on the reason of
defection. Olympia Electronics reserves the right to charge or not the buyer the transportation cost.
HEAD OFFICE
72
nd
km
.
O
.
N
.
R
.
Thessaloniki-Katerini
P
.
C
. 60300
P.O.
Box 06
Ε
ginio Pierias
Greece
www.olympia-electronics.gr
[email protected]
INSTALLATION PROCEDURE (For wall mounting only)
1. Install the included mounting accessories to hook the device from the mounting holes (Fig. 1)
.
2.
Unfasten the 4 mounting screws to remove the front plastic cover (Fig. 1)
.
3. Make sure that the battery’s cables are connected to the respective poles. Black cable to (-) pole
and red cable to (+) pole.
4. Install the included cable gland or the rubber o-ring. Pass through the mains cable and stabilize it
by fastening the cable gland. Connect the wires to the terminal blocks
L for live wire and
Ν
for
neutral
.
The luminaire must be connected to a permanent electrical installation
to ensure
the
immobilization of the cable.
5.
Refit with care the front plastic cover, by fastening the 4 mounting screws (tightening torque
1Nm).
WARNING!! After the installation has finished, charge the batteries for at least 24 hours so as to obtain the rated autonomous
duration
.
TEST
button
Cover
retaining
screws
Fig
.
1
Charge
indicator
Power
indicator
Mounting holes
N
4
3
L
