Page 4 from 6
922504417_09_032
2. Place the plastic part
1. Open the pre-etched knock out and pass the
cable through.
3. Place the cable holding accessory and mount it by
tightening the screw with the included grommet.
5. Place the mounting accessories in the wall
and tighten the mounting screw figure 1 step 3.
6. Place the plastic cover.
Wall in bottom view
Wall mounted installation
using the special mounting
brackets contained in the
package.
Flag mounted installation on
a wall using the special
mounting bracket contained
in the package.
2.
Place the single mounting plastic part
3.
Tighten the mounting screw.
1. Open the pre-etched knock out and pass the cable
through.
5. Place the mounting accessories in the wall
and screw the mounting screws
Wall mounting
4.
place it in the plastic mounting part.
Connect the wires to the included terminal block and
6. After finishing the installation,
the cable
suitable cable detention bracket (not included) to ensure
immobilization of the cable at a distance of no more than
5cm from the luminaire’s cable entry.
secure
with a
