Page 3 from 6
922504417_09_032
4. Connect the wires to the included terminal block and place it
in the plastic mounting part
.
1. Place the plastic mounting part
5. Place the mounting accessories in the
wall and tighten the mounting screw.
2. Tighten the screw.
3. Pass the cable in the canal.
6. Place the plastic cover.
S2
MLD-28 S: 22cm
MLD-34
28
S:
cm
MLD-44
37 5
S:
. cm
Use a certified electrical box 250V
AC (IP40) to
perform the electrical connection, with minimum
internal space 35x35x25mm to install the 3 pole
terminal block. In this box install a certified 3 pole
terminal block 250V
AC/16A
2,5mm²
providing
terminals to connect the live wire L,
the neutral
N
and the ground GND. To this terminal block is
connected the power cable with a cross section of
1,5mm². Install the electrical box in an appropriate
area in the ceiling. Install securely the 3 pole
terminal block and perform the connection according to figure 3.
The electrical box and the 3 pole terminal block not included. Installation may require
advice from a qualified person.
Electrical box
(Not included
)
Figure 2
ELECTRICAL BOX INSTALLATION
1.
Attention!!!
Interrupt the mains power supply.
2. Perform the preparation procedure for ceiling mounting on
page 2 and exclude step 4.
3. Perform the procedure for ceiling mounting figure 1.
4.
For the installation of the electrical box you may need to
open holes in the ceiling and at it’s cable entrances, for the
entrance of the power and illumination sign’s cables. Install the electrical box next to the sign so as
to cover the cable (figure 2
).
5.
After mounted the electrical box open the cover and perform the electrical connection according to
Figure 3. After the connection close the cover of the box.
6.
Power the illumination sign and check the illumination sign’s operation.
OPTIONAL !!
When a triple core cable must be used, then follow the figures 2,3 bellow.
Ceiling mounting
220-240V
AC/50-60Hz
BLUE
L
GND
N
BROWN
Electrical
box
Figure 3
