1
Required opening
14.5x14.5cm
4
3
4
6
8
9
wall plug
wall plug
screws
screws
plastic
mounting
bracket
luminaire’s
base
923493000
_0
9
_003
Page
4 from
7
MOUNTING IN SUSPENDED CEILING
1. Detach the front cover by applying pressure using a flat blade screw driver. Next, unfasten the four
retaining screws (figure 1) without removing them and remove the diffusor.
2. Install the supplied cable grommet from the inside of the plastic base (figure 2).
3. Install the two plastic brackets with the four screws (figure 3)
.
4.
Mark the positions of the mounting holes on the brackets.
5.
Install the two supplied plaster board plugs by screwing them on the plaster board ceiling.
6.
Open a cable entry cutout hole on the plastic base and follow step 3 in the “
initial installation
”
section
.
7.
Re-install the front cover that was removed in step 1.
8.
Use the supplied screws to fasten the luminaire to the plaster board plugs (figure 8) that were
previously installed on the plaster board ceiling.
9.
Finally, install the supplied decorative bezel (figure 9). The notch on the bezel must be
located on the left side of the luminaire (figure 10).
2
