67.
Installation of 8
Polygal Panels
is next. Start by removing protec-
tive plastic layer from each panel. Exterior/interior side of protective poly-
gal film is printed on film, be sure to note the side and install accordingly.
Slide panel up between
Rafters
so it rests on
Polygal Support Cleats
.
From the inside, carefully slide end of
Polygal Panel
underneath roof.
Position
Polygal Panel
equally between
Rafters
.
Polygal Panel
will
overhang end of
Rafter
by 1/2”.
Parts (Steps 67 - 69)
Polygal Panels
(48” long)
x 8
Hardware (Steps 67 - 69)
SS1 - 1” Screws
x 72 total
68.
Drill pilot holes with 1/8” bit through
Polygal Panel
and
Polygal Support Cleat
once
aligned. with
6 - 1” screws
, secure panel to
Polygal Support Cleats
. Polygal is delicate, tight-
en screws a half turn at a time so screws are flush with top of
Polygal Panel
. Use
3 - 1” screws
to secure
Polygal Panel
to underside of Roof
Batten
.
69.
Position and secure remaining
Polygal Panels
as per
Steps 67 - 68
.With a caulking gun,
apply silicone to seal gaps between
Rafters
and
Polygal Panels
. Apply silicone down each side
of
Rafter
. Use liberal amounts to properly seal.
Toll Free 1-888-658-1658 www.outdoorlivingtoday.com [email protected]
Page 36