26.
Complete remaining Side and Rear Top Plate
attachments as per
Steps 24-25.
1-888-658-1658 www.outdoorlivingtoday.com [email protected]
Page 14
27.
When all Walls and Top Plates are attached
together, check wall and floor alignment. Bottom
wall framing should sit flush with outside of floor
joists. See
Steps 15-20
for correct alignment.
Confirm Door Jambs are 64” apart at top and
bottom of door opening.
When positioned correctly, fasten bottom wall
plates to floor using 4 - 2 1/2” screws per wall
panel.
Bottom Wall
Framing
Confirm 64” Wide between Door Jambs
Caulking
Optional
- Caulking
seams will help prevent
moisture from entering at
seam.
Caulking not included in
kit.
Angle
screws into perimeter
Floor Joists.
Important:
Prior to fastening walls and installing rafters, take time to confirm your walls are level,
square and plumb. Measure diagonal at top and bottom of walls corner-to-corner. This should be
approximately 95 1/2”. More importantly, if measurements are not within 1/4”, your walls are not
square. Adjusting now will make it easier to install the roof section later.