Toll Free 1-888-658-1658 www.outdoorlivingtoday.com [email protected]
Page 13
27.
With Roof Panel aligned correctly, from the inside, attach walls to roof with 2 1/2” screws. Screw
from upper framing into Roof Panel. Use 3 screws per each side and 4 across the back. Screw on
angle so tip does not go completely through roof panel.
29.
Locate
Vertical Door Frame Trims (O).
Position on
Front Narrow Wall flush with outside of wall framing. Attach
with 6 - 1 1/4” finishing nails. Complete both sides.
28.
In the front, screw from Door
Header into Roof Panel with 3 - 2 1/2”
screws. Screw on angle so tip does not
go completely through roof panel.
Flush with
wall framing.
Upper Door
Stop not shown
Left Door
Right Door
Hor. Door Trim flush with
Outside/ gap Inside
Door Flange
1/2” x 2 1/2” x 61 3/8”
30.
Locate both
Doors (Q’s)
and
Door Flange (HH).
Flip
Left Door
over on flat level ground and slid Door
Flange tight against recessed Hor. Door Trim. Attach
with 4 - 1” screws evenly spaced top to bottom.
2 additional 1” screws are supplied reinforce if
necessary. Flange not required for Right Door.
4 - 1” Screws.
Pre-drill to pre-
vent splitting
Flip Left Door Over.