Olsen PERFORMANCE TABLE, User Manual

Page: 12 / 72

12
5.5 - Paper Roll Holder (Optional)
Positioned on the back of the backrest,
this holder can receive rolls up to 100 mm in
diameter.
To place the sheet roll on the stand: turn
the holder's shaft (1) clockwise, by pulling it in
the opposite direction to the backrest. No need
to remove the 2 shaft ends. Just remove one
side only to put the disposable sheet roll.
Note: the disposable sheet roll does not
accompany the stand.
5.6 - Instrument’s Tray (Optional)
Fixed to the metal frame of the equipment,
the instrument's tray assembly remains stable while
the table performs the movements.
The instrument's tray (1) is made of stainless
steel and can be autoclaved.
To adjust the tray position: use the plastic
knob adjustment (2).
To adjust the height of the tray: loosen the
plastic knob of the bracket (4), position the arm (3)
at the desired height and tighten the plastic knob of the bracket (4).
The instrument's tray also has free rotation on its axis and can be adjusted.
5.7 - Left and Right Bracket Locks (Optional)
Used to attach accessories to the side rails, the
supports are identified according to the side of the
chair to be installed. The support on the left side (1)
receives the letter L and the right (2) receives the letter
R.
To adjust the height (6) or turning (7) of the
accessory: turn the plastic handle (3)
counterclockwise. Adjust the accessory to the desired
position and tighten the plastic handle (3) by turning it clockwise.
To adjust the position on the rails (8): pull the metal
lever (4) counterclockwise by loosening the bracket on the side
rail. Adjust the accessory to the desired position and turn the
metal lever (4) clockwise.
Note: the metal lever (4) moves only in the area indicated in the figure
to the side. To turn it the metal lever (4) clockwise, push it upwards
causing the lever to pass through the metallic knob's axis (5), and
then rotate it again.