26
WHAT TO DO IF YOU SMELL GAS
Do not try to light any appliance.
•
Do not touch any electrical switches; do not use
•
any phones in your building.
Immediately call your gas supplier from a neigh-
•
bor’s phone. Follow the gas supplier’s instruc-
tions. If you cannot reach your gas supplier, call
the fire department.
CAUTION
!
Use only your hand to turn the gas ball valve. Never
3.
use tools. If the valve will not turn by hand, do not try
to repair it, call a qualified service technician. Force
or attempted repair may cause fire or explosion.
Do not use this appliance if any part has been under water.
4.
Immediately call a qualified service technician to inspect the
appliance and to replace any part of the control system and
any gas control which has been under water.
OPERATING INsTRuCTIONs
sTOP! READ ThE sAfETy INfORmATION AbOvE
bEfORE OPERATING ThIs APPLIANCE.
Set the thermostat to the lowest setting.
1.
Turn off all electrical power to the appliance.
2.
This appliance does not have a pilot. It is equipped with an
3.
ignition device which automatically lights the burner. Do
not try to light this burner by hand!
Remove the front jacket panel.
4.
Turn off the gas ball valve. Valve handle should be perpen-
5.
dicular to the gas pipe.
Wait 5 minutes for any gas to clear. Then smell for gas,
6.
including near the floor. If you smell gas, STOP! Follow
instructions on this page under “What To Do If You Smell
Gas.” If you do not smell gas, go to next step.
Turn gas ball valve to the “on” position. The handle on the
7.
valve should be parallel to the gas pipe.
Replace the front jacket panel.
8.
Turn on all electrical power to the appliance.
9.
Set thermostat to desired setting.
10.
If the appliance will not operate, follow the instructions “To
11.
Turn Off Gas To Appliance” (below) and call your service
technician or gas supplier.
TO TuRN Off GAs TO APPLIANCE
Set the thermostat to the lowest setting.
1.
Turn off all electric power to the appliance if service
2.
is to be performed.
Remove the front jacket panel.
3.
Turn gas ball valve off, handle should be perpendicu-
4.
lar to the gas pipe.
Replace the front jacket panel.
5.
Safe lighting and other performance criteria were met
6.
with the gas manifold and control assembly provided
on the boiler when the boiler underwent tests speci-
fied in ANSI Z21.13-latest revision.
Control Valve “OFF”
Control Valve “ON”
XIII - PuTTING ThE bOILER IN OPERATION
