14
5.9.5
- Swivel Armrest
To move the swivel armrest: press the trigger (1) and push the armrest down.
6
- Instruments Operation
- Pneumatic Handpiece Couplings
Before starting the operation connect the handpiece (1) to
the coupling by attaching it to the coupling ring (2), ensuring that it
is properly connected and that there is no leakage of air or water.
To activate the rotation: press the propulsion/activation
pedal (5). The higher the pressure applied to the pedal, the more
speed in the handpiece, until reaching the pressure limits of the
equipment.
To adjust the spray: turn the adjusting ring (4) until the
desired volume of water. To adjust the maximum flow of water. To adjust the maximum flow of
water, bring the spray adjustment indicators (3) closer to each other. To decrease the flow of
water, rotate the ring so it distances one indicator from the other. The completely opposite
points indicate the minimum water regulation for the spray.
- Optical Fiber Handpiece (Optional)
Before starting the operation connect the optical fiber
handpiece to the coupling by attaching it to the coupling ring (1),
ensuring that it is properly connected and there is no leakage of
air or water.
To activate the rotation: press the propulsion/activation
pedal (2). The higher the pressure applied to the pedal, the more
speed in the handpiece, until reaching the pressure limits of the
equipment.
To turn the
coupling’s
light On/Off: use the On/Off optical
fiber light (3) on the command panel (
section 5.4
and
5,7
) of the
working table.
To adjust the spray: use the optical fiber water control knob
(4) on the instrument control panel.
- Scaler with LED Light (Optional)
Before starting the scaler operation, install the tip on
the transducer (1) and connect the transducer (1) to the
coupling (3) checking if are connected.
To attach the transducer to the coupling: align the
adjustment indicators (2) of the two parts and carefully
insert them.
To install the scaler tips: insert the tip into the
transducer (1) by threading it carefully, then insert the
Torque wrench (4) into the tip and then rotate it clockwise
until it is tight. To remove the tip, turn it counterclockwise
with the Torque wrench (4).
To install a file adapter (not supplied with scaler): attach the adapter to the transducer (1) and screw it
