Königshütte
Lima 2.0 6 kW
Pellet stove
GB
Operating manual
for the user
Tip!
Refill the pellets while the pellet fireplace is cold!
Warning! Risk of serious personal injury,
property damage and/or environmental damage!
●
The pellet fireplace may only be fired with pellets which
comply with DIN EN 14961-2 and the DIN-plus certification
programme or the Austrian standard M 7135: Max. moisture
10%, max. diameter 6 mm, max. length 30 mm!
●
Store pellets in a dry and dust-free location!
●
Do not allow any materials other than the pellets specified
above to get into the burner trough! Burning other flamma-
ble materials or waste causes damage to the pellet fireplace
and results in invalidation of the warranty!
●
Never use flammable liquids such as petrol, lamp oils simi-
lar to petrol, petroleum, firelighters, or similar liquids to kin-
dle or “reignite” a fire! And make sure that such liquids are
a sufficient distance away from the pellet fireplace during
operation!
●
Pellets may never be manually placed into the burner
trough, with the following
exceptions
: during recommis-
sioning and if the reservoir runs empty, a handful of pellets
must be poured into the burner trough towards the ignit-
er. Otherwise, only the pellet duct will be filled within the
filling period in the start phase and only an insufficient 2-5
pellets will fall into the burner trough.
Fig. 3.6
Prohibited filling
Attention! Damage to the surface of the coating!
The pellet fireplace is coated with a high-quality tempera-
ture-resistant coating which only reaches its final strength
after being heated for the first time.
●
You therefore should not place anything on the tiled pel-
let fireplace or touch the surfaces as this may damage the
coating!
●
Never place the pellet sack on the hood!
●
Make sure that packaging does not touch the hot surfac-
es when pouring in pellets as the packaging residue can be-
come burned into the surface of the coating!
3.3 Switching the pellet fireplace on
●
Set the master switch to “I” (back right of the appliance)!
After switching the master switch on, the touch control panel
display is automatically activated and the “HOME display” appears.
If no buttons are pressed for 5 minutes, then the display switches
off (energy-saving mode). The HOME display appears again if the
display is touched.
Fig. 3.7
Switch on with the master switch
Note:
the smell which may occur as a result of curing of the
protective coating will disappear once the pellet fireplace has
been burning at full power with good room ventilation for
several hours.
We reserve the right to make technical changes
47
| 100
Summary of Contents for Lima 2.0
Page 15: ...K nigsh tte Lima 2 0 6 kW Pelletofen DE Technische nderungen und Irrt mer vorbehalten 15 100...
Page 33: ...K nigsh tte Lima 2 0 6 kW Pelletofen DE Technische nderungen und Irrt mer vorbehalten 33 100...
Page 98: ...K nigsh tte Lima 2 0 6 kW Pelletofen Pellet stove Po le pellets...
Page 99: ...K nigsh tte Lima 2 0 6 kW Pelletofen Pellet stove Po le pellets...
