Olsberg Corona Series, Manual

Page: 10 / 28

1 0
Wall installation
IMPORTANT: DO NOT install the device directly be-
neath a wall-mounted power socket.
Fit the wall-fixing bracket (fig. 1 ) in such a way that the
convector unit lies in a horizontal position when in-
stalled. The attachment bracket should be fixed to a
level wall surface. Use the fixing screws (4.5x40) and
wall plugs (
∅
6mm) supplied for this purpose.
Two further screws are supplied to prevent the
wall bracket working loose after installation.
Screw them into the holes provided (Z) in the clip
mechanism of the wall-fixing bracket.
Note: Use the wall-fixing bracket as a template for
marking the position of the unit and the location
of the drill holes.
Type
Dim.
L
Dim.
A
Dim.
B
Dim.
C
No. of fixing
screws
1 5/ 1 92 340 1 56 94 90 3
1 5/ 1 93 340 1 56 94 90 3
1 5/ 1 94 420 236 94 90 3
1 5/ 1 95 500 1 78 2 1 5 1 07 4
1 5/ 1 96 580 248 204 1 28 4
1 5/ 1 97 660 320 2 1 2 1 28 4
1 5/ 1 98 740 405 207 1 28 4
1 5/ 1 99 900 535 237 1 28 4
Observe the international safety regulations regarding
minimum clearances when installing the unit in rooms
equipped with bath or shower.
If the unit’s connection lead is damaged, ensure that it
is replaced immediately with the appropriate original
part (available from the manufacturer or an authorized
service provider).
Locate the device on the open clips at the bottom, on
the wall-fixing bracket, and push in until the spring-
loaded catches at the top and/or sides engage in the
recesses provided in the rear panel.
To release the spring-loaded catch once it has en-
gaged, push on the upper or lateral clip with a screw-
driver or similar (see fig.
1 – item Z and fig.2 – item E).
Convector unit 15/192 /193 /194
Convector unit 15/195 /196 /197 /198 /199
fig.1
fig.2
item
E