12
Foreword
This electronic oven controller OEC II is a top product
of modern firing technology.
In the OEC II, the combustion air supply is automatical-
ly controlled during the entire combustion cycle and the
convection air output dynamically adjusted depending
on the room temperature.
Through the shut-off of the combustion air supply at the
end of the combustion cycle, heat losses are avoided
during chimney stove downtime.
High operating comfort, low emissions and high fuel
utilisation characterise the mode of operation of the
OEC II.
Proper installation as well as correct handling and
care are vital to trouble-free operation and a long life.
Therefore, please follow all the instructions in this
manual.
Keep this manual on hand so that you can always con-
sult it as to correct operation at the beginning of the
heating period.
If you discover any transport damage, please report
this to your supplier immediately; otherwise there can
be no settlement claims free of charge.
Regulations to be observed
● Local building regulations.
● The OEC II must be connected and put into opera-
OEC II must be connected and put into opera-
must be connected and put into opera-
tion by a qualified professional.
Electronic Oven Controller OEC II
23/6841.9200
Table of Contents
Foreword ................................................................. 12
Regulations to be observed .................................. 12
Installation ............................................................... 13
Delivery contents ...................................................... 13
Installation steps ....................................................... 13
Operation ................................................................. 17
Function of the combustion air regulation................. 17
Function of the convection air regulation .................. 17
Commissioning ......................................................... 18
Setting of the electronics ....................................... 18
Shortened or extended combustion cycle ................ 18
The display of the electronics ................................... 19
Operator‘s menu ....................................................... 19
Change primary air shut-off time
with sub-menu PAS .............................................. 19
Select control curve with sub-menu tYP ............... 19
Acoustic signal on/off with sub-menu bEP ........... 19
Change display brightness with sub-menu JAS ... 19
Display in standby mode on/off with
submenu Sut“ ....................................................... 20
Code word change with sub-menu EPS ............... 20
Control parameter for convection air .................... 20
Manual air slide valve operation ........................... 20
Power failure ........................................................... 20
Fault indications ..................................................... 21
What to do if ...? ...................................................... 21