6. AUTOMATIC OPERATION TIME PROGRAMMING INSTRUCTIONS
PROGRAMMING MUST BE DONE ONLY WITH
THE PANEL IN STAND BY POSITION
A.
Select the desired function level by pressing the reference button on the remote control
B.
The number of the selected level will appear on the panel display
C.
Press the button again for at least 10 seconds
D.
The letter P will appear on the panel with a flashing light at the top left
E.
The light will flash twice and then the number from one to 9 hours will appear
F.
The light will continue to flash. release the level key and immediately access the + key
G.
The sequential numbers of the hours will appear on the display. use the + - key to select the number
of hours you wish to make the panel work
ATTENTION:
the + key must be pressed with the light flashing. If the light does not flash, memorization is not
activated. in which case, repeat.
EXAMPLE PROGRAMMING AND DISPLAY IMAGES
FIGURE M
Selection
power level
Appears letter
P
two flashes
Appears number.
Light flashes
Number of hours
the operating
Press again the key
for
10 seconds
Hold down
Let key
+
o
-
Press in sequence
key
+
o
-
10
