Oliver M1013, Owner'S Manual, Page: 32 / 37

32
Troubleshooting
During operation:
Item Problem Check up Solution Note
3 Bit breaks while carving.
Turn on Emergency
Stop button.
Turn off the power
switch.
Unsecure the nut on
the bit
Use wrenches to re-install
the bit.
Unload the ER-11
chuck
Install a new bit.
To lock the bit, push up
the bit .Then, secure the
nut.
The causes of Bit breaks:
1. Cutting depth is over-
loaded. 2. The hardness
of the material is too high.
3. Bit becomes dull.
Restart carving your
workpiece.
4
The outcome does not
match your computer file.
Ensure you install the
right size of the bit for
your project.
5
Blurriness on your work-
piece.
Your workpiece is
composite wood.
Use brush to clean the
surface of your workpiece.
6
Lines or curves on your
workpiece.
Check the software
setting and the bit.
Clean the rails and lead
screws.
Contact your local dealer
or distributor if this does
not help.