Oliver M1013, Owner'S Manual, Page: 31 / 37

31
Troubleshooting
During operation:
Item Problem Check up Solution Note
1
Select “Enter” to carve, but
axes do not function.
Ensure axes make a
small shift.
Time counts down
shows on the display.
Turn off Emergency
Button to stop carving
the project.
Turn off the power
switch in the rear of
the unit.
Take apart the front
cover where the axes
locate.
Use the T wrench to fix
the axes.
Check if the motor
wire is loose.
Ensure terminal pin is
tight.
Secure the cover back
to the place. Then turn
on the power switch.
Select “Enter” to
carve.
Contact your local dealer
or distributor if this does
not help.
2
Abnormal noise or vibration
occurs while axes are oper-
ating.
Turn on Emergency
Stop button.
Turn off the power
switch.
Unsecure the nut on
the bit.
Use wrenches to reinstall
the bit.
Unload the ER-11
chuck
Clean the bit, chuck
and nut.
Use compressed air to
clean sawdust.
Reinstall the bit.
To lock the bit, push it up.
Then, secure the nut.
Contact your local dealer
or distributor if this does
not help.