Page | 9
Location.
The selected location for the installation must also have sufficient space
around the equipment for proper ventilation. Do not block the equipment airflow
filters. The selected location must have sufficient space around the Electrical cabinet
(if equipped) for working clearance as prescribed by the National Electric Code
Selection 110-26 or local Authority Having Jurisdiction.
When locating your stoner, be sure that you leave adequate clearance to
operate the controls and to remove the deck for changing or cleaning. To operate
the controls and provide normal maintenance, we recommend a minimum of 4 ft.
clearance. A space approximately equal to the dimensions of the deck is adequate
for deck removal from the heavy end. Please refer to our layout print at the end of
these instruction manual for dimensional information.
MINIMUM 4 FT
CLEARANCE
Figure 1: Destoner
installation
CLEARANCE TO OPEN
ELECTRICAL CABINET DOOR
Summary of Contents for Hi-Cap N Series
