732-N Front Load Slicer
0732S20007
6-13
Adjusting The Blade Frames When Slices Vary In Thickness
WARNING
ALWAYS DISCONNECT THE SLICER FROM THE POWER SUPPLY BEFORE
ATTEMPTING ANY TYPE OF MAINTENANCE TASK.
Assuming that the lower blade frame has been installed and centered in the machine,
meaning that it has been aligned with the slots in the top cover and holddown, and
secured with the locking cams, proceed as follows to adjust the upper blade frame. If
the lower blade frame has not been centered the same process to be described for
adjusting the upper blade frame should be used to center and secure the lower blade
frame before you proceed.
To adjust the upper blade frame loosen both locking cams, and also loosen the set
screw securing the “Locking Collar”. Once this is done take a small hammer or mallet
and tap the blade frame either to the right or left to equalize the distances between the
blades. Once this is done secure the locking collar with the set screw and retighten the
locking cams. After the covers have been replaced the machine should be ready to use.
PDF compression, OCR, web optimization using a watermarked evaluation copy of CVISION PDFCompressor