732-N Front Load Slicer
0732S20006
5-3
Trouble Shooting (Continued)
Bread Slices Vary in Thickness
•
The blade frames are out of adjustment. (See the “Maintenance” section of this
manual under “Adjusting the Blade Frames When Slices Vary in Thickness” on how
to correct this problem.)
The Blade Frames Are Knocking
•
The blade frames are out of adjustment. (See the “Maintenance” section of this
manual under “Adjusting the Clearance Between the Blade Frames” on how to
perform this adjustment.)
The Slicer Vibrates Excessively
•
The drive belt is loose or worn. (See the “Maintenance” section of this manual under
“Tightening the Belt” or “Replacing the Belt” on how to make these corrections.)
•
One or more of the bearings on the machine are failing. (Have a qualified service
agent check for defective bearings and replace them as required.)
•
The pins, (two eccentrics and two regular), and links at the top of the blade frames
are worn. We suggest that these be replaced together. Mixing worn parts with new
will shorten the life of the replacement parts. Remember, after replacing the pins
and links the clearance between the blade frames must be re-adjusted. (See the
“Maintenance” section of this manual under “Adjusting the Clearance Between the
Blade Frames” on how to perform this adjustment.)
The Hand Lever Pulls Hard
•
Check the Cradle guide tracks at each end of the cradle bracket for a build-up of
foreign material.
Continued
PDF compression, OCR, web optimization using a watermarked evaluation copy of CVISION PDFCompressor
