18
SECTION 8 : ADJUSTMENT INSTRUCTION
-------------------------------------------------------------------------------------
Adjust conveyor table
To adjust the conveyor table left to right:
1.
Disconnect the resaw from the power source!
2.
Use your test board to determine which direction the conveyor table needs to be moved. For example,
if the right side of the board was thicker than the left side
—you will need to move either the right side of the conveyor up or move the left side of the conveyor
down.
3.
Loosen all six of the conveyor mounting bolts
.
4.
To raise the left side, loosen the lock nuts on the conveyor adjustment bolts on the left side and
tighten the adjustment bolts. Do the same procedure to the right side bolts to raise the right side.
5.
Tighten the lock nuts on the adjustment bolts and tighten the conveyor mounting bolts.
6.
Connect the resaw to the power, and repeat steps 1 and 2.
—If the measurements are close to correct, but need fine tuning, continue to step 6.
—If large adjustments are necessary, repeat steps 3 and 4.
7.
Loosen the cap screw shown below.
