13
SECTION 6
：
INSTALLATION
------------------------------------------------------------------------------------
Mounting resaw to the floor
We recommend that you bolt your new resaw to the floor. Because this is optional and floor materials
may vary, floor mounting hardware is not included. It may be necessary to level the floor before installing
this machine.
Note
：
The instructions below are given for a typical heavy-duty shop floor made of 6" thick concrete.
Also, anchor studs may be substituted for lag bolts, but they will stick out of the floor if you decide to
move your machine at a later point.
To mount the re-saw machine to the floor
：
1. Put on safety glasses and a dust mask before starting!
2. Use the mounting holes in the resaw stand feet to act as a guide for drilling into your floor, and drill
approximately 3-1⁄2" deep into the concrete floor.
3. Using compressed air and a vacuum, remove the concrete dust from the newly drilled holes.
4. Using the hammer and punch, pound the lag shields into the concrete below the stand feet and flush
with the surface of the concrete.
5. Secure the resaw to the floor with the lag bolts and washers.
