Check the wiring and change if necessary.
S E n S o r
Display
E r r o r
Possible cause:
a. no
sensor
b. 9-pin connector is loose
c. Wire
broken
d. The gap between sensor and tape is too large
Excluding: Check the sensor, sensor cable and sensor connector.
E r r o r
Display
Possible cause: Incorrect operation.
Excluding: Press
to clear.
C H A n G E
Display
b A t t
This message appears after power-on and indicates battery discharged. The C-type
battery MUST be replaced to resume the operation of the device. Change as follows:
1. Open the planer’s top right side panel to access the rear of the Controller.
2. Turn the power off. Be careful not to move the table during power off. Replace
the battery and turn the power on. The device will resume normal operation.
