2019 Lathe
OLIVERMACHINERY.NET
23
|
Page
Tailstock and Quill
The sliding tailstock can be mounted on any location on the lathe bed.
Lift the lock handle to secure the tailstock on the bed.
The quill on the tailstock is extendable to push the mounted accessory
towards the headstock. When the quill is equipped with the live center
shipped with this lathe, the tailstock can be used to secure a workpiece
on the lathe.
The quill position can be locked by the quill lock. The quill lock has a ratcheting handle, which can be
moved to a different position if blocked.
IMPORTANT
Do not apply excessive pressure on the workpiece by over extending the quill.
This can cause the spindle bearings to heat up and wear prematurely. Apply just
enough pressure to secure the workpiece on the lathe.
Release the quill lock before adjusting the quill position. Failure to do so can
damage the quill.
The quill accepts accessories with an MT-2 taper. Before inserting an
accessory, make sure the tapered contact surface is clean. To unmount
an
accessory, retract the quill until it passes beyond the 0” mark on the
gauge, and the accessory should detach from the quill.
With boring accessories installed, the tailstock can bore a hole into the
workpiece. Use the scale on the quill as a depth gauge to make sure the
bored hole is not too deep and damage the workpiece.
Banjo and Tool Rest
The banjo supports the tool rest and can be mounted in any position
on the bedways. Use the locking lever to clamp the banjo on the bed.
Before turning the workpiece, ensure the height of the tool rest is
properly set. Use the clamping lever to secure the tool rest to the banjo.
The clamping lever has a ratcheting mechanism and can be lifted and
moved to a different position if it is blocked. It can also be mounted on
either side of the banjo.
The banjo accepts
any tool rests with an 1” post. When purchasing additional banjos,
ensure the girth and
length of the tool rest post match the tool rest shipped with this lathe.
Extension Bed
Use the extension bed for outboard turning, or use it to extend the
main lathe bed to maximize the center-to-center capacity to 41
.
To install the extension bed, align the holes on the extension bed with
the pins on the mounting point, then secure the extension bed with the
four M10 socket head cap screws.
When mounting the extension bed to the main bed, use a straight edge
to verify the bedways are flush and level, and the gap between the
bedways is aligned.
Summary of Contents for 2019
