10
troubleshooting
Problem: Frisper is not working and there is no sound
when i press down on the lid.
Is the electrical cord plugged into a 120 V AC outlet?
Plug the Frisper into a wall outlet.
•
Is the terminal connector of the adaptor plugged into
the Frisper?
Plug adaptor into the rear terminal of the Frisper.
•
Is the correct AC adaptor used?
Check the adaptor to make sure it’s the Frisper’s.
•
Is the LED indicator light off?
Check the above 2 steps
•
Is the lid closed down firmly?
You will hear a ‘click.’
•
Problem: Bag and food are wet.
Always par freeze liquids first before frisping.
•
Pat meats or vegetables dry before frisping. Use a
•
paper towel as a blotter inside the vac-snap zipper bag
— it becomes a wick and helps to seal moist foods.
Problem: Bag is leaking air.
Is the heat sealed circle complete? Is there a tiny puncture
somewhere on the vac-snap zipper bag?
Visually inspect the vac-snap bag. Check the heat seal
•
impression left on the bag.
Re-frisp if necessary.
•
Is the zipper closed completely?
Re-zip again using the zip-disc.
•
Are you using a Frisper vac-snap zipper bag?
Zipper bags from the grocery store aren’t made
•
strongly enough, and air passes through them.
Problem: the Frisper sounds like it is working but…..
nothing is happening.
Are you trying to Frisp from a used spot on the bag?
Open the Frisper and move the bag to a fresh spot to frisp.
•
Are you overlapping or too close to a used spot?
If so, move the bag away from the used spot by
•
1/4-inch and try again.
Is the vac-snap zipper fully closed?
Re-zip again using the zip-disc.
•
Are the foods in the bag fatty or juicy?
With a clean dry paper towel, wipe down the zipper treads on the
•
inside of the bag.
Is food bunched up and under the Frisper lid?
Remove bag from Frisper, shake food to opposite side and re-frisp
•
the circle you have already started. Make sure you line the puncture
tooth up and directly over the puncture you just made.
Is the drip tray full?
Empty, rinse out and thoroughly dry.
•
Is the heat-sealed circle complete and is the thickness of the seal even?
and through?
Visually review the heat seal impression left on the bag. If the seal
•
is not even and through, line up the puncture tooth over the hole it
made and re-frisp.
Is the flexi tube plugged into the Frisper’s flexi tube valve port?
Remove flexi tube and re-frisp.
•
Did you firmly press down on the lid? or just tap it?
Open lid, make sure puncture tooth is aligned. Press firmly down on
•
the lid and let go.
Is the vac-snap zipper bag edge lined up along the drip tray marking
line? Is the vac-snap zipper bag overlapping the inside of the Frisper
and bunched up under the lid?
Open the lid, move the bag edge to run parallel to the drip tray edge
•
with the zipper facing right or left.
