7.
COMMISSION
MENU ................................................................................................................................. 24
7.1.
Navigating the menu ................................................................................................................................. 24
7.2.
Setting the control logic (Ctrl.state) ......................................................................................................... 25
7.3.
Setting the status of the 2-way valve in cooling mode (Cool 2-Way valve) ........................................... 26
7.4.
Setting the status of the 2-way valve in heating mode (Heat 2-Way valve) .......................................... 26
7.5.
Setting solar system integration (Solar setting) ..................................................................................... 26
7.6.
Setting the installation of the Water tank
............................................................................................... 27
7.7.
Setting the use of an external thermostat (Thermostat) ........................................................................ 27
7.8.
Setting an additional heat source (Other thermal) ................................................................................. 28
7.9.
Setting an additional heater (Optional E-heater).................................................................................... 29
7.10.
Setting the installation of the remote room temperature probe (Ambient sensor) ............................ 29
7.11.
Setting the air purging function (Air removal) ........................................................................................ 30
7.12.
Setting the pre-heating procedure for radiant panels (Floor debug) ................................................... 30
7.13.
Activating the defrost cycle (Manual defrost) ......................................................................................... 30
7.14.
Activating mode forcing (Force mode)..................................................................................................... 31
7.15.
Activating auxiliary device management (Gate-Ctrl) ............................................................................. 31
7.16.
Setting the intake limit (Current limit) ..................................................................................................... 31
7.17.
Setting the serial address of the unit (Address) ...................................................................................... 32
7.18.
Setting the refrigerant recovery function (Refri. recovery) .................................................................... 32
7.19.
Setting the management logic for the Tank heater
..................................
.............................................
32
7.20.
Setting the maximum temperature for the DHW storage tank via heat pump only (T HP max) ......... 33
7.21.
Setting the cooling operating time (Cool run time) ................................................................................ 34
7.22.
Setting the heating operating time (Heat run time) ............................................................................... 34
8.
General
MENU ........................................................................................................................................... 34
8.1.
Navigating the menu ................................................................................................................................. 34
8.2.
Setting the unit of measurement (Temp. unit) ........................................................................................ 34
8.3.
Activating/deactivating the memory (On/o
ff
memory) ......................................................................... 35
8.4.
Activating/deactivating the sound (Beeper) ........................................................................................... 35
8.5.
Setting the display lighting (Back light) .................................................................................................. 35
8.6.
Setting the system date and time (Time&Date) ...................................................................................... 36
8.7.
Selecting the system language (Language)............................................................................................. 36
8.8.
Activating the WiFi (WiFi) .......................................................................................................................... 36
9.
ALARM CODES ............................................................................................................................................ 37
Summary of Contents for SHERPA MONOBLOC
Page 191: ......
Page 192: ...262617B...
