Olimpia splendid CALDO UP T WIFI, Instructions For Use And Maintenance Manual

Page: 33 / 297

CALDO UP T WIFI EN - 13
ENGLISH
3.4 - FUNCTIONING
3.4.a - Fan mode
While using this mode, the appliance doesn’t exert any action neither on temperature
nor on air humidity in the room. When pressing the ON/OFF button, the appliance
starts in this mode. The
FAN
LED on the appliance display turns on.
3.4.b - Minimum power heating mode
With the appliance on in fan mode, press key to activate the minimum heating power.
In addition to the
FAN
LED, the
LOW
LED also switches on on the appliance display.
3.4.c - Maximum power heating mode
With the appliance on in minimum power mode, press key twice to activate the
maximum heating power. In addition to the
FAN
LED, the
HIGH
LED also switches on
the appliance display (and the
LOW
LED switches off).
It is also possible to activate this mode through the START/STOP button on
the back of the appliance (pos. 12 - figure X).
Press button START/STOP again and the unit switches to STAND-BY mode
(and switching off occurs as described in the next paragraph).
If one of the heating modes has been activated, press the ON/OFF button
to turn the appliance off, the FAN LED starts flashing and the display starts
the 30 seconds countdown after which the appliance turns off (as well as the
FAN LED).
3.4.d - ECO mode (temperature setting)
Ambient temperature is shown on the display when the appliance is turned on.
When the appliance is on, pressing button will cause the temperature value to
flash and the set temperature value to be shown.
Within 5 seconds, press buttons and to set the desired temperature (range:
18°C÷45°C - 1°C variations). To confirm the setting, please wait 5 seconds; the display
goes back to show ambient temperature.
If the set temperature is slightly higher than the ambient one (+1÷2°C), the minimum
power heating function activates automatically (
FAN
and
LOW
LEDs turned on).
If the set temperature is greatly higher than the ambient one (>3°C), the maximum
power heating function activates automatically ( FAN and HIGH LEDs turned on).
If the set temperature is lower than ambient temperature, the appliance ends heating
function, after 30 seconds the fan stops (
LOW
and
HIGH
LEDs flashing) and flap
oscillation stops (LED flashing).
The set temperature can be changed at any moment during functioning.